Customer Support Center: Knowledge Base

Fingernail cuts can occur on the smooth surfaces of a wetsuit. This is usually the result of pulling too hard when putting the suit on or by catching or pinching the surface of the wetsuit with your nails. While we make every effort to ensure that our products use the toughest materials available you should be aware that as a performance product wetsuits are not bullet proof and occasionally small tears do occur. Should a tear or fingernail cut occur, then repairing it yourself is a very simple 5 minute job.

Supplies: You will need neoprene repair cement. Optionally you can buy a puncture repair kit from any bike store (the glue used to fix bike tire innertubes is basically the same). You will also need a small brush (such as an artist's painting brush) or a spatula (which can simply be a thin piece of plastic or card).

Step 1: Fold the wetsuit over at the point of the cut so that it opens up to reveal the two surfaces that need to be glued back together.

Step 2: Apply a thin, even layer of rubber cement glue to both surfaces. Continue to hold the cut open while the glue dries. Do not rejoin the surfaces while the glue is still wet or tacky.

Step 3: The glue will only take 1 to 3 minutes to dry (depending on room temperature and humidity). The glue looks glossy when wet. It will become matte when dry. Once it appears dry, then check it by gently touching the glue surface. It will feel only slightly tacky and will not stick to your finger.

Step 4: Flatten out the suit so that the two surfaces come together. The bond is instantaneous.

Step 5: Pinch the two surfaces firmly together and you're done!

Note: The suit can be used in the water right away. However, the maximum bond is achieved over a period of 4 to 6 hours. Therefore, you should avoid putting any immediate pressure on the repaired surface.